|
Don’t have a dyno tuning center nearby? Are you
more of a do it yourself type? Are you constantly changing parts on your
bike?
If you answer "yes" to any or all of the
questions above, then The Dynojet AutoTune kit is for you. The Dynojet
AutoTune kit is an "add on" accessory that can be used with any Power
Commander V.
It connects to the Power Commander V with a
single cable and requires only a ground and +12 volt connection to be made
to install. If your exhaust does not already have one, a "weld in" O2 sensor
bung is included.
Dynojet has taken virtually the same
technology that their patented Tuning Link dynamometer software (for
automated Dyno tuning) uses, along with Bosch Wide Band O2 sensors and
miniaturized it to be used on your bike while you ride.
Once installed, the Dynojet AutoTune kit
monitors the fuel mixture by installing the included Wide Band O2 sensor in
the exhaust. It then sends this information to the Power Commander V and
automatically corrects it while you ride. Each map has preset Air / Fuel ratio
values included that Dynojet finds to be the best overall settings. This
lets you simply plug in the unit and let it do the work.
For advanced users that would like to change
the Air / Fuel ratios from the baseline they are fully adjustable. Each
throttle opening / rpm combination is individually adjustable so that you can
have fuel economy while cruising, while maintaining peak output at
larger throttle openings. For most motorcycle models it is also possible to
adjust the Air / Fuel ratios "per gear". This gives you total control of the
fueling in every gear and throttle / rpm area if required.
The Dynojet AutoTune kit can be configured to
run and correct at all times or by using the "map switch port" on the PCV
you can set it up so that you can switch back and forth between the tuning
modes and the base map settings. You can also configure the Dynojet AutoTune
kit to wait until the bike is at a certain operating temperature before
beginning to make adjustments.
Single Channel AutoTune Kit with 1 Wideband O2 Sensor
The single O2 sensor kit is a universal fit that can be used on any
vehicle that has a PCV installed on it. It comes with a single O2 sensor,
cut to length sensor cable, control module, O2 sensor weld on bung and
CAN connection cable. It requires a ground and +12 volt connection be made
using the supplied Posi-Taps.
Dual Channel AutoTune Kit with 2 Wideband O2 Sensors This dual O2 sensor kit is a universal fit for twin cylinder motorcycles
that use the Power Commander V allowing control of two cylinders
simultaneously. The kit includes two sensors and PCV connection harness.
Installation Instructions (click to
open or right click save as to your computer)
|
